- $2.99
Magic Anti-gravity Sphere
This magic sphere rises up when you pull down on the string!
Printing Instructions:
PLA recommended.
Print all models at 150um layers (0.15mm).
3 Perimeters, 3 top and 3 bottom layers minimum recommended.
Special print settings for outside ball:
Support material 30 degree overhang.
Seam position - rear (if using shiny filament, for better part finish).
PLA recommended.
Print all models at 150um layers (0.15mm).
3 Perimeters, 3 top and 3 bottom layers minimum recommended.
Special print settings for outside ball:
Support material 30 degree overhang.
Seam position - rear (if using shiny filament, for better part finish).
Contents
32_16 Pulley.stl
- 111 KB
Inside Half B.stl
- 206 KB
Inside Half A.stl
- 221 KB
Outside Ring.stl
- 149 KB
Outside Ball Half B V2.stl
- 455 KB
Outside Ball Half A V2.stl
- 463 KB