In addition to the printed parts you will also need OD 6mm x 3mm deep magnets 24pcs. You can find suitable magnets here.

GENERAL PRINTING INSTRUCTIONS:

0.15mm Layer heights, 3 perimeters, support material off.

SPECIFIC PRINTING INSTRUCTIONS:

Bottom Cap, Top Cap: Consider aligning perimeter seams for a cleaner finish.

Egg Pieces: Print 5 of each minus one for Middle Logo Tile. 

UPDATE: Optional numbered 5th pieces added to assist in correct arrangement (in case the color order is too difficult to remember). 

Middle, Outer Rails: Enable "avoid crossing perimeters" or similar feature to minimize stringing and blobs on sliding surfaces.

Centre Rod: Easily knocked over. Recommend using a brim and slow print speed.

Avoid excessive elephants foot or the parts will not slide smoothly.

Assembly instructions in the video: